Canopy top mockup with Brian and I inside.

Fabricated right angle attach points for seat belts. Will attach them to hard points tomorrow.

Seatbelt hard points installed. Aircraft birch plywood and 7 layer BID. Super strong!

Shoulder harness hardware installed.

Glassed and wrapped.

Ready to glass passenger headrest.

Makeshift vacumn bag in pilot headrest. Not sure how this will turn out.

Shoulder support glassed.

17 layer hard points glassed in place.

Headrest mockup before glassing exterior.

Shoulder support floxed in place.

Hinges trimmed and countersunk.

Nut plate floxed is place. This will be inside the shoulder support.

Ready to trim and drill hinges.

Canopy hinges floxed and clamped in place.

Canopy hinges prepped and ready to flox.

Inside glassed and nut plates floxed in place.

Shoulder brace ready to glass inside.

Shoulder harness attach points

Close up.

Hard points floxed in place.

Centering hard point inserts.

Headrests sanded and ready for glass.

Headrest pieces floxed together.

Headrest foam cut.